Bottle Water Rinser

Standard Features:

Fixed rpm gearmotors on rinser gripper chains and infeed conveyor.
Adjustable spray header.
Stainless steel construction, #4 finish.
Gripper adjustments achieved by means of a single handwheel (no tools required) with numerical counter to indicate width between grippers.
Soft ribbed rubber grippers to gently grip each container, eliminating potential label damage to pre-labeled containers.
Positive emergency discharge jam switch to stop equipment.
Downstream back-up control sensor.
C.S.A. approved stainless steel electrical enclosure with controls, starter, frequency inverter for soft start/stop functions and variable speed control & Allen Bradley Micrologix 1000 c/w hand held programmer.
Link-Belt Klean-Gard polyamide bearings.
Stainless steel adjustment chain.
Centralized and conveniently located grease manifolds.
14" stainless steel tabletop infeed conveyor drive section.
14" stainless steel tabletop discharge conveyor idler section.
Rinse media low pressure sensor which will automatically stop rinser.
Automatic "Air/Water Saver" rinser spray shut-off (no container/no spray).

Standard Options:
Automatic two speed functions (high/low)
Pulse link which requires 0-10 V DC signal from the filler
Combination air/water manifold

Air Units Only:
Vacuum manifold for collecting airborne particles
Shockless ionizer nozzles with power supply
Customer to supply 40 psi clean, dry, oil free air)
Constant duty vacuum system with a unique reverse pulse
cleaning system which is both effective and gives prolonged
filter life. Collection sack has a 30 liter capacity and a vacuum
sound level of <75dB (A)
Air filtration kit consisting