Versatile sorting device for all caps with a wide range of geometries but practically limited to 70mm diameters. Typically runs standard 28mm and 38 mm flat caps at rates of over 100CPM. Custom tooling allows conical, “Yorker”, pour spout and other specialty caps to be run in this system.

Vibratory cap pre-feeder is used to meter caps into the centrifugal sorting bowl at a rate consistent with the sorters output. This device is necessary to prevent the centrifugal sorter bowl from jamming by having too many caps present. Not recommended for large caps greater than 70mm

Fully automatic large capacity unit with floor level 5+ cubic foot cap bin feeds various cap sorters.

Fully automatic unit with 5 cubic foot floor mounted cap bin sorts caps as they are elevated. Gravity forces incorrectly oriented caps to fall back into the bin for resorting. System is for higher speed sorting of flat caps where the diameter is greater than the height. Primarily for small flat caps up to 70mm.

Fully automatic unit with 10 cubic foot floor mounted cap bin sorts caps as they are elevated. Gravity forces incorrectly oriented caps to fall back into the bin for resorting. System is typically used for larger diameter flat caps (> 70mm) where the diameter is greater than the height but may also be used for high speed sorting of small caps.

Fully automatic Hazardous Location cap sorter sorts caps as they are elevated out of a large hopper. Similar in design, function and construction of our standard bulk elevator but built to meet Class I Division I electrical standards. Unit uses slats spaced on the elevator chain to sort a range of caps. Additional sorting chains may be needed to work with all samples provided.